News

Raymond mill has a certain moisture content in the material being ground in the grinding chamber, which generates heat during grinding and increases the air volume in the grinding chamber. Therefore, the balance of air flow is achieved by adjusting the residual air duct between the fan and the host, and the excess is purified and discharged into the atmosphere. The cloth bag should be shaken frequently to ensure good exhaust effect. This article will provide a detailed explanation of its working process.

1. The working process of the host is driven by the transmission device to rotate the central shaft. The upper end of the shaft is connected to a plum blossom frame, which is equipped with a grinding roller device to form a swinging fulcrum. It not only rotates around the center, but also revolves around the grinding ring while the grinding roller rotates on its own due to friction.

2. The analyzer drives the blades on the turntable to rotate through a variable speed motor, forming a sub machine effect on the powder.

3. The performance of the multi grinding powder machine in the large cyclone collector plays a very important role. When the powder laden airflow enters the collector, it rotates at high speed. When the airflow separates from the powder, it moves towards the center along with the contraction of the conical wall to form a rotating upward airflow cylinder at the bottom of the cone, which separates and collects the powder.

Precautions for using Raymond mill:

1. In order to ensure the normal operation of the Raymond mill, a "Equipment Maintenance Safety Operation System" should be established to ensure the long-term safe operation of the Raymond mill. At the same time, necessary maintenance tools, lubricating grease, and corresponding accessories should be provided.

2. When replacing the grinding roller of Raymond mill after using it for about 500 hours, the rolling bearings inside the roller sleeve must be cleaned, and damaged parts should be replaced in a timely manner. The refueling tools can be manual refueling pumps and grease guns.

3. During the use of Raymond mill, there should be fixed personnel responsible for supervision, and the operators must have a certain level of technical proficiency. Before installation, the Raymond mill operator must receive necessary technical training to understand the principles and performance of the Raymond mill and familiarize themselves with the operating procedures.

4. After using the Raymond mill for a period of time, maintenance should be carried out, and vulnerable parts such as the grinding roller, grinding ring, scraper, etc. should be repaired and replaced. The connecting bolts and nuts of the grinding roller device should be carefully inspected before and after use to see if there is any looseness and whether the lubricating grease is sufficient.